Another ATX bench power supply

myminifactory

Another ATX bench power supply, inspired by myminifactory.com/object/3d-print-atx-power-supply-280126 (thanks Maker-Y!), but designed from scratch, so there is no need for cutting PS wires that you dont use - there is enough place inside between PS and housing to store them away (proprerly insulated). Behind the front panel some hooks are added for better wiring organization. Other changes are:- not using DC Power Supply Jack Socket Female- added two LEDs (blue and red) for indicating operating status- used 8 Ohm, 25 W Aluminum Housed Resistor as load- used VA meters for each fixed voltage output Printed with 0.2 mm resolution, 20% infill, supports needed for some parts. Front panel printed with filament change above 4mm (above layer 20) for texts and markings. Housing screws holes are printed small (if wider needed, just drill them out a bit), so any screew for plastic will fit. Part "top back" is made with extension (if you want to mount ATX breakout board between "top back" and "bottom back"). If your PS's vent opening is more on the left side use "top back-left", for right sided vent openings use "top back". Also there is "top back - wide" part for PS with vent opening at different position (it should fit for all). Changelog: V1 - added fuse for USB circuit protecion, removed current labels for fixed voltages outputs on front panel, changed schematic diagram. Parts List: 1 x ATX power supply unit1 x Aluminum Housed Resistor 8 Ohm, 25 W8 x Banana Socket (4 x red, 4 x black) 5 x Fuse Holders1 x QC 3.0 USB Charger Socket1 x DC Buck Boost Converter1 x 2 Positions Connector Terminal1 x Switch3 x VA meter2 x LED (red, blue)2 x 330 Ohm 1/4W resistor24x screew Many assembly instructions can be found on net if you just google for "ATX bench power supply instructions", I have used video published by Maker-Y.