Anjunabeats Nightlight

thingiverse

An Anjunabeats logo that includes a spot to install a Wemos D1 Mini knock-off. No tracks for LEDs; first print used WS212B strip with adhesive backing. It might be hard to fit it in the build volume from to back. It is possible to fit rotating it just so that the smaller portion of the logo fits in one corner and the tip of the larger end is right at the edge of the opposite side of the build plate. Tolerances were a bit tighter than I expected. It will press-fit as is, but it's hard work to get the Wemos in and you might not be able to get it apart again. The transparent insert on the front side has a hole so you can reset the Wemos if needed; omit at your discretion! To print it without a loop (e.g to use to hang it from something, use the "no loop" outer frame. Finally, to print just a curio with no space for a microcontroller or LEDs, there's an inner and outer frame version at the same exterior scale but only half as tall. Enjoy!