Animatronic Halloween Crow

thingiverse

This is a remixed crow animatronic. Code is currently not available, but should be fairly easy to setup using danman's crow, and adding the additional servo for the beak.Pictures will be added after completion. ChangesHead:Made hollowPrecut holes for 5 mm ledsPrecut wire holeSplit into lower beak, base, and top sectionsAdded servo that can open and close beakBody:Made hollowPrecut servo hole and wire channelOpened up, and added holes for magnetsFeet:Added pins. A dremel will be needed to make holes in the body. This does make it much easier to glue in place right now. I may update the body in the future. Tail:Made hollowAdded holes for magnetsAdded hole for powerServo holes are made to fit 24x12 mm servosAssemblyInsert servo into bottom of head.Insert lower beak into posts, hold in place with 2mm rodRun music wire or similar through holes in jaw, connect to servo armWire leds for headInsert head base + beak assembly into head. Squeeze the sides of the jaw, it should pop through all the wayScrew/glue base and head togetherNote You may need to remove additional material from the bottom of the opening in the head for smooth movementInstall servo into top of body, connect servo arm, glue or screw everything together as needed. Future:I plan on adding pins to the legs and body to make assembly easier. Until that happens follow danman's instructions in the original.