Angled Foregrip

thingiverse

I designed this after the Stark SE-5 Express. The Hole is intended for M5 screws that are 35mm in length and a Nut that measures 8mm side-to-side. If your grip becomes too tight on your Picatinny rail, I suggest heating the print slightly before sliding it back and forth to achieve your desired resistance level. The interior of the grip features a hollow design, as evident in one of the provided screenshots. This was done to minimize print filament usage. When slicing the file, you can also observe the hollow interior. If you are not experiencing warping on the flat side of your print, I recommend printing the grip at an angle, similar to the images shown, or where the Picatinny rail is perpendicular to the print bed.