Angled Display / LCD - Maker Select Plus

thingiverse

I originally created this mod because I required extra clearance at the front of the Y axis of my printer due to modifying my print bed to a longer 275mm x 220mm. The original metal back plate of the LCD stuck out too far and obstructed the bearing slide blocks' full travel. Also, the LCD circuit board was just a tad too tall and was being nicked by the slide blocks without the metal back in place. So I decided to move it to the front. I successfully achieved 240mm of usable Y axis travel after taking a Dremel to the rear of the printer belt channel hole and this modification. I might go back and lengthen the channel a bit more in the rear to gain hopefully 10mm or more clearance. Needed Materials: x2 M3 6mm Screws x2 M3 10mm Screws x4 M3 16mm Screws x4 M3 nuts, I used lock nuts just because that was what I had lying around