Angle Adjustable Motion Sensor for Home Assistant (RCWL 0516 + Esp32 via ESPHome)

thingiverse

Case for a RCWL-0516 Microwave Motion Detector connected to a ESP32 (ESP32DEVKIT1) that serves as a motion detector via ESPHome to home assistant. Sensor part can be adjusted by 90º. Printing can be done without supports - just turn all parts into the correct direction so it can print bottom up: The viser on the flas surface, the ESP-Case on the inclined surface and the wall mount flat, where the wall would be. Sensor can be attached to wall with the included wall mount Material list: - 4 x 16mm M3 screws (panhead) to assemble - RCWL-0516 - ESPDEVKITV1 Esp32 - some jumper-wires to build the circuit. The RCWL-0516 works like an PIR-Sensor for ESPHome. Just connect the signal pin to the PIN configured in the ESPHome-config GPIO12 in the example below). For the rest of the config please refer to https://www.home-assistant.io/ and https://esphome.io/ My ESPHome Config: `binary_sensor:` `__- platform: gpio` `____pin: ` `______number: GPIO12` `______mode: INPUT_PULLUP` `____name: "PIR Sensor"` `____device_class: motion` (replace leading _ with spaces)