AnetA8_E3D_V6_Holder_TronxySensor

thingiverse

This is a remix of Dousi's Anet A8 Bowden conversion, reworked with adjustments made for my Divaks E3d V6. I found that the Hotend Holder required tweaking as it seemed too short, so the Fan duct was lower than the nozzle. I added slots to the part fan, allowing it to be moved up and down. This modification enables any fan duct to potentially work with this mount. The same change was made for the Tronxy Sensor; I wasn't comfortable with a fixed point. All modifications were done in 3DS Max and run through Netfabb to double check for any errors. **UPDATE** **Hotend_Holder** After printing the Hotend Holder, I noticed that the X-Carriage no longer fitted because I made it too thick on one part. The sensor mount needed extending as the sensor was above the fan duct, so it wouldn't lower down to its tolerance. **X-Carriage** I remodeled the X-Carriage since I didn't want the name attached and added cable covers on the sides with hinges to keep the sensor, hotend, and fan cables tidy. **Not printed this remodel yet, so unsure if the hinges will work properly; print Dousi's as it still fits all these parts** **Fan_Duct** The original Fan duct was too small for my heating block and .4 nozzle, so I modeled a Square fan duct that fits around the Heating block. This design and the slots on the Hotend Holder enable easy positioning up and down to find the perfect height to cool your parts