Anet heatbed RPi camera arm

thingiverse

*Edit 2018-02-21:* I've made a note that the version with the built-in cable clip is extremely challenging to print correctly. However, you can achieve the same result by simply attaching a small foldback clip to the vertical shaft of the mount. *Edit:* After making some adjustments, the clip should now be able to be printed flat without any supports. I'll put it to the test again tomorrow and make sure everything is working smoothly. By the way, I forgot to include the clip in my initial design - I'll upload an updated version with the ribbon cable clip attached soon. To create this project, I took c_wolsey's RPi heatbed camera mount ([here](https://www.thingiverse.com/thing:2010139), which was a remix of papinist's [here](https://www.thingiverse.com/thing:1867549)), and made some slight modifications. First, I narrowed the clip that attaches to the bed by 0.5mm, which resulted in a much tighter fit. Then, I filleted the spine on the arm, allowing it to be printed sideways without any supports. I also lengthened the arms on the camera tilt mount because I noticed that the original design tends to fold the ribbon cable over. Additionally, I merged it with WaveSupportApparatus's ribbon cable clip ([here](https://www.thingiverse.com/thing:1037722)), which keeps the cable out of the way. I'll be posting photos soon to show you how everything fits together.