Anet-ET4_Z-Axis Stabilizer

thingiverse

Inspired by the design submitted by RbnTool, I recreated the component to fit an M4 bolt and eliminated one corner as I have an Anet ET4 Extruder Rolling Filament Guide - by AndrEwIICZ - installed, which clashes with this part at maximum Z-height. Materials: * eSUN PLA+ (Red) * 608 Bearing * 1x M4 x 20mm Hex Bolt & Washer to Suit * 1x M4 T-Slot 2020 Hammer Head Nut Settings: Printed on Anet ET4 (stock), using Cura 4.6.1: * Layer Height: 0.3mm * Line width: 0.4mm * Wall Line Count: 2 * Printing Temperature: 210 °C * Bed Temperature: 60 °C * Infill Density: 30% * Infill Pattern: Grid * Print Speed: 50mm/s Assembly Instructions: I made sure the bolt hole accommodates a 9mm OD flat washer. To make bearing installation easier, I submerged the printed part in hot water (just off boiling), then dried it thoroughly and fitted the bearing. This means when removing the bearing afterwards, the part will likely need to be destroyed. The part should be installed with the bearing visible from the bottom.