Anet ET4 upgrade: X gantry cable holder

thingiverse

To prevent damage and potential breakage to the X gantry data cable, upgrade its design to avoid movement at the board connector when the Z axis is in motion. The X stepper's backplate is secured using 1mm thick sponge-like biadhesive tape. It's not necessary for the screws to be snug; just a light tightening will suffice. Required components: * 4 M3 screws with 15-20mm thread length * 4 M3 nuts Note: Different bottom bracket versions exist. WITH SUPPORTS: I added four small crosses at the hex holes of the lower bracket to create a base for the supports. Without these, it's impossible for the supports to adhere properly to the bed. You can later remove the entire support system using a small cutter. WITHOUT SUPPORT: Print as desired without any modifications.