Anet ET4+ cooling

thingiverse

Cooling for Anet Et4 Plus with changed part cooling fan for a 4020. Most probably i will change some stuff in future in this design. Printing: nozzle: i used 0.6mm and everything was ok supports: used auto supports for angles over 80* and blocked supports inside Infill: zig zag - 45% Speed: Should be lower then 60mm/s (30-40mm/s should be enought) if you want to print the inside without supports. Issues: The part cooling fan blow is shifted too far to the right - I'll fix it in the future Additional Credits: matosantos - for sending me a file with correct sizes od the mounting holes so i could start designing without maesuring them on the printer control3d - because when I saw his cooling design i knew that I should make something simillar.