Anet E12 holders for two Mosfets

thingiverse

I liked the design by Mr_3D, but I only allowed mounting in one location and I wanted to use Mosfets for the Heated bed and the Extruder. I designed a second mount that can be placed on where the front fan is located. To make it easy to put in place, remove the LCD display to give access to the fan screws. The rear mount was Dr_3D design with the mounting flange trimmed down; it looked like it would be really hard to get into place in my E12 controller case. You may have to extend your wires to reach the front fan mount location for the Mosfet board terminals. If you like this design, then you might also like these other designs for the Anet E12: Two-Piece Cooling Fang; Anet E12 legs using current rubber feet; Anet E12 make the control unit a part of the printer; To fix the issues with leveling and unwanted bed movements (bed shifting); Anet E12 bracket for SIQUK MK8 Extruder upgrade; Anet E12 quick lock for the SIQUK MK8 Extruder upgrade; Anet E12: Cable strain relief for heated bed (improved); Anet E12: Y belt tensioner; Anet E12: X belt tensioner.