Anet E12 Carriage Shroud

thingiverse

This is another remix in my series. This one is designed for the Anet E10/E12. I've made a few key adjustments:\r\n\r\n* Lowered the layer fan output by 4mm, so the air hits the bed instead of the thermistor\r\n* Added some angled edges to minimize the need for excess supports (and cleanup)\r\n* Installed top clips on the layer fan, allowing you to use only the two original screws at the bottom\r\n* Smoothened out some holes to improve print quality\r\n* Added two sloping ducts just above the heat block to prevent the print from melting\r\n* Removed the peculiar round pad under the layer fan nozzle\r\n* Created a notch on the back of the layer fan plate for routing fan wires\r\n* Increased the venting on the right side of the heatsink for enhanced airflow\r\n* Corrected some irregular geometry at various points in the model\r\n* Rounded out some corners and edges to make it more visually appealing\r\n\r\nThree components are included.\r\n* Complete fan assembly with duct\r\n* Just the duct (for those wanting to reposition it according to their setup)\r\n* Just the spacer (for those wanting to reposition the duct)\r\n\r\n===============================================================\r\n\r\nIf you'd like to support my work, or purchase me a Monster (I don't consume alcohol or beer), you can visit my Patreon Page:\r\nwww.patreon.com/m1dn1ghtn1nj4\r\n\r\nA portion of every month's earnings is donated to a charity chosen at the end of each month!