ANET A8 Z Endstop fine adjustment

thingiverse

I made a few changes: - The Leg now has a 2.95 mm hole for 3mm screws providing enhanced stability, eliminating the need for drilling or heating. - The Foot has been completely redesigned with a big flat bottom and is easy to attach using a 3mm screw making it perfect as a turning knob for calibration. Assembly instructions: - Attach the switch holder to the frame, then add the switch - Pass an M3x35 or similar through the legs hole - Secure the foot to the screw, tighten it slightly but avoid over-tightening which may deform the bottom surface, you can glue the screw into the foot for a better hold. Calibration: Turn the screw using the six sided foot and enjoy! Note: A well-calibrated printer is essential for screws to fit snugly in holes. If it doesn't fit, simply scale up the model by 1-3%. To set your z axis, remember that one complete turn of the M3 screw equals 0.5 mm.