Anet a8 Z axis sync & Anti Wobble

thingiverse

I have viewed several sync systems and they all seem a little too complex. So adapting my https://www.thingiverse.com/thing:5787411 A8-Anet 004.stl Anti Z Wobble. I added a little extra to the Right side for the sync system. If your preference is on the left side open the stl file in Tinkercad , click on file to activate, go to a corner marker to show width, activate width number, put a minus in front of number, enter, and you then have an opposite hand plate. You will require a few items to make this operate... 2 GT2 pulley with an 8mm bore 1 GT2 pulley with a 5mm bore 1 GT2 lay pulley (as direction pulley) 1 m5 Set Screw + washers & nuts (of adequate length) for GT2 1 m5 set screw + washers & nuts (of adequate length) for lay pulley 1 closed loop GT2 belt (Measure the distance around the route of the belt to ensure correct size, getting the nearest oversize) Print a Wing Nut from Remi-Rafael @ https://www.thingiverse.com/thing:5532943 Loop belt length (circumference)= Distance (mm) from outside of lead screw to outside of lead screw x 2 + 16= circumference / 2 = number of teeth Please leave a like and if you do print this please leave a make. or as well Maybe a coffee with you, leave a donation at https://paypal.me/3dtinker