Anet A8 Y-Axis Cable Chain - Right Side

thingiverse

This is my take on the Anet A8 Y-Axis Cable Chain. The chain lies neatly to the right side of the heated bed, well out of the way of the extruder's home position. To get started, print 14 separate chain segments and rotate your heated bed a full 90 degrees clockwise, so that the connectors end up on the right-hand side. Print Settings Printer: Anet A8 Rafts: No Supports: No Resolution: 0.3 Notes: You can print these parts at a layer height of 0.3 mm or higher, and crank up the speed - precision isn't crucial here. However, assembling the chain can be a bit tricky (but it works out fine in the end). Initially, the chain is a tad too tight, but some gentle fiddling will get it to loosen up nicely.