Anet A8: Tool Holder 2 (Right side)

thingiverse

This is for the remaining tools (clipper and spanner) and uses existing holes in the Perspex, just like the other side. To use these holes, you must first unmount the power supply and then reverse one screw so that its cross head is behind the power supply. This will allow the power supply to fit back into place. When reinstalling the power supply, place two washers on each of the three screws that secure it between the acrylic and the supply, acting as spacers. This allows the power supply to sit evenly and prevents overheating. It's also beneficial because it prevents heat from transferring to the plastic frame, which can affect your prints. Cura settings: Print upside down and omit support entirely. The tool holder for the other side is available at http://www.thingiverse.com/thing:2072360