Anet A8 Table Mount - Quick and Dirty ;)
thingiverse
Additional material required: 8x Screws, 3mm diameter (dependent on your base/bottom material) Quick and dirty table mounts designed specifically for the Anet A8 Printer. This was a ten-minute print with low resolution, but still yielding the best optimization in noise/vibration terms. The printer is nearly silent now, compared to its previous state. ***Installation Instructions:*** 1. Print Part four times. 2. Attach "clip" mounts onto the threaded shaft. 3. Mark down the position of screw holes or directly drill holes (e.g., 2mm hole for 3mm screws). 4. Ensure mounts do not touch the bottom surface yet. 5. Screw down the mounts to the base/bottom plate with two screws each. Six grams of filament were used for four pieces.
With this file you will be able to print Anet A8 Table Mount - Quick and Dirty ;) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Anet A8 Table Mount - Quick and Dirty ;).