Anet A8 Strain Relief

thingiverse

**General Information** This strain relief is designed specifically for the Anet A8 heating bed connector. Due to normal movement of the heating bed, individual pins may not make proper contact, potentially leading to high heat generation inside the plug. This strain relief prevents movement on the plug and thus on the pins, ensuring a clean connection between the six leads of the heating bed. The pins in the plug are decoupled from the movement of the heating bed, eliminating potential issues. **Requirements** The strain relief is designed for use with the "Bohrers" heating bed holder in combination with the "Bohrers" silicone buffers. To install this strain relief, your printer must have the following parts installed: * Heat Bed Holder * Silicone Buffer You can purchase these required parts from the Bohrers website. **Needed Parts** To assemble and use this strain relief, you will need the following components: * 1 x M4x8 screw * 1 x M4 nut * 2 x M3x10 screws * 2 x M3 nuts **Disclaimer** By using this strain relief, you acknowledge that I assume no liability for damage caused by improper use, incorrect commissioning, unsuitable accessories, or failure to observe safety precautions. You use the strain relief at your own risk; I am not responsible for any issues that may arise.