Anet A8 - Sensor Support

thingiverse

Two pieces rear support are needed for the 13mm inductive sensor. No additional support is required. Four M3 screws are necessary. Below, the Marlin settings are defined: **define X_PROBE_OFFSET_FROM_EXTRUDER +21 // X offset: -left +right [of the nozzle]** The X axis probe offset from the extruder is set to 21 units. **define Y_PROBE_OFFSET_FROM_EXTRUDER 59 // Y offset: -front +behind [the nozzle]** The Y axis probe offset from the extruder is defined as 59 units. **define Z_PROBE_OFFSET_FROM_EXTRUDER 0 // Z offset: -below +above [the nozzle]** The Z axis probe offset from the extruder is set to 0 units. **define LEFT_PROBE_BED_POSITION 5** **define RIGHT_PROBE_BED_POSITION 195** **define FRONT_PROBE_BED_POSITION 50** **define BACK_PROBE_BED_POSITION 205** These define the positions of the probe on the bed.