Anet A8 Prusa Top Frame Brace (M10 variant)

cults3d

I had a 3/8" threaded rod from the hardware store, so I needed to adjust this a little. While I was in there, I realized that the design might be better as a wedge-shape to make sure it's nice and snug. I printed this in TPU to get a "rubber stopper" effect, but it should work just fine in PLA or whatever you typically use as well. Print 2, put 2 bolts (3/8" bolts for 3/8" rod, naturally) on each end of the rod to lock them down. I'd probably cut the rod needed down to 320mm or less instead of the 350 recommended on the original as well since this part is smaller. I've included my OpenSCAD file as well so you can customize the spacing or whatever you'd need to.