Anet A8 Plus BLTouch Sensor Mount (sag resistant edition)

thingiverse

I noticed after a few prints that the BLTouch sensor was sagging and I had to constantly adjust the Z-Offset. Nwpvr mentioned the sagging in his comments as well. I took that design and put a 2mm hole through it and then stuck a wood toothpick through the hole to strengthen the holder. This is the same as Anet A8 Plus BLTouch Sensor Mount by Nwpvr only with a 2mm hole going through it. I've printed a few hours with this and do not see the same sagging issue. This Part is a BLTouch Sensor Mount for Anet A8 Plus (not the original) This Part is installed at the left part of the extruder, You may need to get some extra long bolts to replace the originals. Or some screws may work. The distance between the nozzle and the sensor is X axis -54, Y axis -21 (This can be incorrect! Best recommend to measure yourself)