Anet A8 Heatbed Camera Mount Logitech C920

thingiverse

This is a remix of https://www.thingiverse.com/thing:2008595. Excerpt from the original: >This make is for a bracket that attaches to the hotbed of Anet A8 printers, allowing you to mount a camera in place. The bracket fastens to the top of the H-bracket, below the actual hotbed. We reuse the holes for linear bearings and an end clamp to attach the mount to the H-bracket. There are two versions of the bracket, one that attaches to either the back right or front left side of the printer. The other version attaches to either the back left or front right side. A minimum of one bracket needs to be installed. For each bracket you will need: 4x M4 12mm bolts (these will replace the M4 8mm bolts attaching the H-bracket to the bearing), 2x M3 10mm bolts, and 2x 10mm nuts (these attach the clamp). Please note that clearance under the clamp and the overhang of the bracket is critical to prevent attachment from crashing into printer supports. Check clearance on installation and before each use. Damage to your printer is not my responsibility. ##### TL;DR Required hardware (all from spare parts that came with the Anet A8) - 4: M4 12mm screw - 2: M3 10mm screw - 2: M3 nuts - For each arm: M3 20mm screw & M3 nut I found there wasn't enough clearance when a heavy webcam was attached, so I made more. I also created a way to mount a Logitech C920 webcam that can be easily removed but holds on quite tight. Currently, I am using the mount in the back right of the heat bed and have had good success.