Anet A8 E3Dv6 carriage

thingiverse

I created this carriage because none of the available options met my standards. While the type of material may not be crucial, I chose PET due to its rigidity and heat resistance. You will need additional screws, as the Anet A8 ones are not compatible. This design accommodates M3 and M4 shoulder bolts of various sizes. The sensor is standardized at 12mm, but I can consider a 16mm version if there's sufficient interest. Proper use of support is essential; failure to do so may result in the top print layer collapsing. The cooling fan is secured using 3M double-sided tape, similar to that found on GoPro sticky mounts. Although it may seem unconventional, this method effectively dampens fan noise and provides adequate support for both the fan and duct. For the duct, I utilized wladq66's extended left duct designed for the Anet A8.