Anet A8 Dual Bowden Conversion

thingiverse

Really liked this design, however wanted to keep my X-Axis chain and needed a mount for the Tronxy sensor. Pulled the blower fan mount further away from the X-Carriage mount as felt it was a bit too tight. Made an attempt at partitioning the fan output so that there was equal flow to each hot end, though not as equal as I'd like still - thus used tape for now. Opted to use https://www.thingiverse.com/thing:2356276 by TGYK for the hot end fan. Printed in ABS, and has held up quite nice for some 24+ hour prints. For my set up, ended up having the second extruder at (X-32.25, Y0). Might also adjust the rear anet_dual_x_carriage_v4 since my X-axis belt was rubbing and added some spacers for the rear Tronxy mount which isn't clear in the photos.