Anet A8 Direct Drive mount for E3D V6

thingiverse

This custom idler is designed specifically for the Anet A8 and should fit seamlessly with its factory idler mounts. Check out this compatible design on Thingiverse: https://www.thingiverse.com/thing:2773206. The stepper motor in this setup is positioned slightly differently to redistribute its weight. To secure the hotend, you'll need two M4 nuts that slide into the bottom of the mount. These nuts have a specific orientation - one point must face upwards - and should only fit in one way. Two M4x20 screws will then clamp the hotend firmly in place. One M3 screw is used to guide the extruder spring, while two M3x18 screws attach the fan mount to the actual carriage. Finally, two M3x20 screws secure the fan to its mount.