Anet A8 Corner Brace Bottom Left Frame (Minimalistic)
thingiverse
I modified the excellent T Brace by Electrico to work on the lower left of the frame. The T Brace worked so well that I decided not to change a thing. I could have added a nicely rounded corner, but I opted for simplicity instead. A small wall was added to the bottom side to minimize the gap. If you've installed any mainboard mod covers that extend to the end, be sure to check if this will interfere with them. There's a notch cut out for the board that rests against the bottom wall, so if your mainboard has different spacers or something else that puts it in a different spot, the notch may not line up. It's possible to print it standing upright like it is or on its flat side with supports all over. I chose to print it on its flat side with supports everywhere. One of the pictures shows what happens when you leave a thin layer of support material behind for a tight fit. Important note: My Anet A8 has the paper still on the acrylic frame, and this fits snugly. Since I can't test it without the paper on an Anet A8, it might need adjusting for a paperless acrylic frame. See other side:http://www.thingiverse.com/thing:2105106 See upper braces by Electrico:http://www.thingiverse.com/thing:1672959
With this file you will be able to print Anet A8 Corner Brace Bottom Left Frame (Minimalistic) with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Anet A8 Corner Brace Bottom Left Frame (Minimalistic).