ANET A8 Complete set E3D V6 Direct Drive with Clamp, Fan Duct and 18mm Sensor

thingiverse

I haven't even touched the mount itself, just added the fan duct and hotend clamp. I printed it at a .3 initial layer height with a .25 layer height, using 35% cubic subdivision infill support from the bed only at 50 mm/s. You should probably add that you shouldn't print it out of PLA if you want it to last. This design can be printed all together on the build plate of an Anet A8 in one go. File 2 includes a heatbrake duct for a 40mm fan. Make sure the heatblock has the heater cartridge towards the rear of the printer, or you'll melt holes in the fan duct. Your X and Y home offsets will change with this mount; it's now -16 for X and -8 for Y. Print Settings: Printer: Anet A8 Rafts: No Supports: Yes Resolution: .25 Infill: 35% Cubic Subdivision Notes: Used a 15mm brim.