Anet A8 Circular Extruder Fan - lowered (various lengths)

thingiverse

Thanks Arjjck for the Hesine M-505 design! I tried several circular extruder fans on my A8, but a lot seemed to be cooling the extruder itself and causing my temps to fluctuate, so I decided to get the fan as low as I could to help minimize this. I attacked Arjjck's design with my limited knowledge of Meshmixer to extend the ring down, and these are the results. On my machine, the 3mm (pictured) is very close to the bed/print and works well. The 4mm extension would probably scrape against my bed/print, but maybe someone else can use it. These fans will likely collide with any clips you may have around the edge of your heatbed, so plan accordingly. Printer: Anet A8 Rafts: No Supports: No