Anet A8 Circular Duct - Taller Version

thingiverse

EDIT 06/26/2018: The original file has been replaced with one I've fully printed and am currently using with great success. This is now safe to use! I've been using Aymanhasan's circular air duct for months, but only now just realized that it sits far too high on my Anet - it should be blowing air directly onto the tip of the hotend and onto the print, but instead, it was just cooling the heat sink block where the thermistor lives. I've extended the duct entry by 11mm, which places it properly over my nozzle. Note: This is a work in progress and may not work for your Anet. I had to purchase an aftermarket squirrel drive for my Anet because my original one broke a blade somehow, so that's probably why the size isn't right. Check your height before you use this! If you want something that will fit with more reasonable certainty, pick up the original version of this file by Aymanhasan, and tip him for a good model!