Anet A8 Bed connector for wire-chain

thingiverse

The original blueprint caused the assembly to wrap around itself while printing because the chain connector wasn't properly aligned with the bed connector. I used one chain connector and created an integrated and partially enclosed design. At the same time, I ordered a new wiring kit from AliExpress that had two black and two red wires connected to the bed along with a specialized fitting into the wide bed-connector. 28-09-2019 : I recently discovered my blueprint was too tall for my setup and also unnecessary so high so I made some adjustments and posted a version that's 4 mm lower. I also made a slight adjustment to the wire path so it's level with the rest. If you enjoy my design and want to make a contribution to support me, my PayPal address is: PayPal.Me/dennisheijmans