Anet A8 bed cable clamp

thingiverse

Not ideal to have the cable crossing over the Y motor and belt. Like many, I printed a Y chain, but it didn't work out well and observed that the connectors were shifting inside the bed connector housing. This will cause fretting and lead to overheating and failure. Much simpler to attach this clamp on the RHS of the (rotated) bed frame. Secure the cable within its sheath to the clamp and direct the other end diagonally to the frame support. Use a P clip in the hole LHS and route the cable vertically upwards with enough slack for full bed travel - stays clear of the drive system and no strain on the connections.