Anet A8 AM8 Control board and FET Driver board enclosure

thingiverse

Update: Feb 29, 2020 V3 of the board now supports both Anet A8 motherboard and RAMPS 1.x with an Arduino mega 2560. The Arduino board is positioned to place the USB connector in the back. This enclosure is designed for Anet A8/AM8 builds. I'm unsure if there's a difference, but it was created for version 1.5 control boards with the reset button in the middle. The enclosure has very tight tolerances around the SDcard slot, making it easy to insert and remove the card and preventing mis-insertions. The cover simply slides into slide slots and then snaps under the clip. Holes are designed for M3 screws that came with the original Anet A8 kit. 5mmx10mm bolts can be used for attaching to 2040 extrusion. Two holes on the right side of the enclosure allow for two-sided attachment, but three outside bolts were enough once assembled. Sketchup files are included for modification in various applications. Credit goes to CPT_Spekkie for designing this. The CAD files were created from scratch based on their design, so I marked it as a remix.