Anet A8 Adjustable Glass Holder

thingiverse

I created a simple glass holder for my Anet A8, using 4mm glass sheet that should still work with 3mm. So far, these are working great. As this is my first design project, any feedback would be greatly appreciated. To ensure success, I recommend using slightly bed level screws to prevent compressing your springs too much. Your glass must be at least 7 inches by 7 inches for this holder to work properly. You can use any size M3 screws to adjust the tension on the glass - a total of eight screws are needed. I suggest printing in ABS, but if you only have PLA and no ABS, then PLA might still work. This design was printed without supports. Print Settings Printer: Anet A8 Rafts: No Supports: No Infill: 20% Post-Printing