Anet A8 30A PSU cover and frame mount

cults3d

This is a cover for the 30 amps PSU (see picture) for anet a8, not the stock psu. Composed by 4 pieces, cover, inner and outer support and pins. Installation instructions: disassemble (WARNING: warranty void) the 30A psu, remove the top cover, two screws for the transistors heatsink remove the electroincs board; remove also the transparent plastic film. Place the two inner supports ad shown in the picture (#2) then reassemble the psu. attach two screws with nuts (i used two anet spare parts) to the frame support (see picture for reference (#4). do this before fixing the support to the psu. use glue, plastic specific to glue the inner support pins to the support and silicone to glue the support to the psu. (notice that i am not so good on glueing silicone, and also notice how to position the frame support with the frame screws, the two additional nuts in the picture will be use to tight the psu to the frame). Install the power button and the power socket in the cover (again for the power socket i used two spare anet screws and nuts) see picture #6 for reference. connect the button and the socket with wires (i soldered them). next connect the 3 wires coming from the socket and the button to the psu and assemle the psu and the cover. i do not have the appropriate screws to tight the psu to the cover so i designed the pins. see picture #9 for the complete assembly. i designed an additional versions to allow the switch in picure #11 to fit , this version is untested.