Anet A6 Y-Axis Cable Chain

thingiverse

I'm going to place my Anet A6 printer in a plywood case and create a custom mount for the X-Axis and Z-Axis cable chain. I'll use the Thingiverse design https://www.thingiverse.com/thing:3650649 as a reference, but make some changes to suit my needs. For this project, I'll start by using the chain from https://www.thingiverse.com/thing:2345005 and create a mount for the printer and hotbed. Since the author of the original design intentionally left large gaps in the chain for easy assembly, I can modify it to fit my requirements. However, the chain does bend to one side due to these gaps, so I'll add custom links to straighten it out. To attach the pipe lying on the base, I'll drill holes for screws into it. The hotbed mount will be attached through the H-frame with four M4x16 screws to a linear bearing. When setting up the table, I need to turn it to the left or right side, depending on my preference. If I choose to turn it to the left, the connector should be sealed off and the wires soldered. On the other hand, if I prefer to keep the table facing itself, the connector can remain intact, but it's recommended to solder the wires for better stability. You can check out all of my products on Thingiverse at https://www.thingiverse.com/Jurist/designs