Anet A6 upgrade: X-Belt tensioner

cults3d

This is the X-axis tensioner so that you can easily adjust the x-axis to turn tighter. You will need a couple of screws and nuts: 1x M3 40 mm 1x M3 30 mm 2x M3 nuts Instructions: Get the right side of the X-axis almost completely apart so you can remove the original bearings holder! Decide whether you want to keep the original right side part or print that one ("X-axis_Tensioner_Frame.stl"). Important: Once you use the original, there is a chance it will break because it's not very strong. I recommend printing "X-axis_Tensioner_Frame.stl" strictly. I am not responsible if something gets damaged, but sometimes the original frame side fits better. Place the required M3 nuts (there are 6 angled holes where they should), and install the bearing. Then slide the "X-axis_Tensioner_Adjustment_holder.stl" in the right way, and you can start reassembling. Once everything is back together, you can install it on the printer and put the belt back on. When everything is in place, you can now start turning the M3 screw until the belt is at the proper tension a little. Have fun with print, assemble, and use! Be sure your printer is calibrated correctly! Otherwise, it won't fit at all!