ANET A6 UPGRADE to SKYNET 2.3.2 AUTO for CURA 2.6.2

thingiverse

ANET A6 UPGRADE to SKYNET 2.3.2 AUTO for CURA 2.6.2 Start: G21; Set metric values G90; Enable absolute positioning M82; Set extruder to absolute mode M107; Turn off the fan at startup G28; Automatically home all axes G29; Automatically level the bed M84; Turn off the steppers M0 S12; Wait 12 seconds M17; Turn on the steppers G1 Z10.0 F300; Move the platform down 10mm fast G92 E0; Zero the extruded length G1 F200 E8; Extrude 8mm of filament at a moderate pace G92 E0; Zero the extruded length again M0 S5; Wait 5 seconds G1 F9000; M117 Printing... M851 Z-0.27; Adjust the sensor offset to -5.00, use my value of 4.73 instead M500; End: M104 S0; Turn off the extruder heater M140 S0; Turn off the heated bed heater if you have it G91; Switch to relative positioning G1 E-1 F300; Retract a little filament before lifting the nozzle to release pressure G1 Z+140 E-3 X+1 Y+200 F9000; Move up, retract more filament, and move the axes M84; Turn off the steppers G90; Switch back to absolute positioning RED no Coping