anet a6 skr v1.3 adapter

thingiverse

Installing a BigtreeTech SKR V1.3 board on an Anet A6 3D printer requires careful planning and execution. Begin by disconnecting the power and unplugging the USB cable from the Anet A6's control board. Remove the four M3 screws holding the aluminum extrusions together, allowing access to the electronics within. Locate the SKR V1.3 board and carefully remove it from its packaging. Mount the SKR V1.3 onto the Anet A6's mainboard using the provided stand-offs and screws. Secure the board in place by tightening the M2.5 screws firmly. Next, connect the SKR V1.3's power and fan connections to their respective ports on the Anet A6's mainboard. Connect the USB cable from the SKR V1.3 to the computer for flashing and configuration. Finally, reassemble the printer by replacing the aluminum extrusions and reconnecting the power and USB cables. Configure the SKR V1.3 board using Repetier-Server or another firmware such as Klipper. Ensure that the correct settings are applied for the Anet A6's motors and steppers. After completing these steps, your 3D printer should be ready to use with its new BigtreeTech SKR V1.3 control system.