Anet A6 PSU cover

thingiverse

So after downloading some power supply covers here and on other sites, none actually fit perfectly or the designers overcomplicated their designs as flip covers with incorrectly measured dimensions by adding swing hinge clips and screw holes that need to align with existing holes in the PSU. I mentioned earlier that none of these worked, especially when you have to scale them during slicing, resulting in a disproportionate outcome. I had a specific power rocker switch with fuse that I wanted to use for this project. So, I designed this cover crudely but very functionally, complete with the official Anet logo. The hole I drilled for the top screw of the switch accidentally aligned 100% with an existing hole in the PSU. Apart from that one screw holding the cover in place, I used two small pieces of double-sided foam tape on the front top to keep the cover securely attached.