Anet A6 Power Switch

thingiverse

Anet A6 power switch --------------------- I created this power switch for the back of my printer because I couldn't find an existing solution to install one at the original power supply location. ### Installation The top hole of the switch is designed to align with the existing power switch's hole, so 40mm screws are required. Due to the small space, it can be a bit challenging to fit the screw from the inside; I used a short (about 9cm) screwdriver for this. Since I'm not an electronics expert, I didn't realize that the switch doesn't come with a fuse, so keep that in mind. The power supply is rated at 12V 20A, which translates to a maximum of 240W. At 230V, it's only capable of providing up to 1A. Based on this calculation, I believe my spare fuses marked 1.6A 250V will be sufficient. Used switch: https://www.amazon.de/gp/product/B01ID44I4S/ Used screws: * 2 x M4, 40mm (for the switch) * 2 x M3, 30mm (to replace existing but shorter screws) * 1 x M3 (for the inner side; an existing screw can be reused) Note: 30mm fits but feels a bit short, while 35mm should be perfect.