Anet A6 Light sockets

thingiverse

These sockets can be installed on top of the ANET A6 printer to illuminate the heatbed. Two holes are available on the side for this purpose. To activate the light, four LEDs with 3mm diameter and one 100-ohm resistor need to be soldered in series. Insert them into the outside holes to achieve the correct spacing. Once the soldering process is complete, place the components inside the socket. It's a snug fit, but with a bit of effort, it can be made to work. For added convenience, consider increasing the height slightly. Next, run the cable to the 12V+ and ground connections on the power supply. It's a good idea to install a switch between them for easy on/off control.