Anet A6 Fan Duct with Light

thingiverse

Hey guys, this fan duct is going to brighten up your prints... You'll need: 4x SMD LEDs, 1206 package; two LEDs in series 2x series resistors; I used two 300Ohm resistors in 1206 package some very thin insulated wire; I had a 0.25mm (diameter of uncoated wire; 0.5mm with insulation) available soldering iron and solder two connectors (one pin, male and female) or one "two pin connector"; I used this one: https://www.conrad.de/de/miniatur-bananenstecker-stecker-gerade-stift-26-mm-schwarz-1-st-730572.html and https://www.conrad.de/de/miniatur-laborbuchse-buchse-gerade-stift-26-mm-rot-1-st-731919.html some wire; I used 0.14mm² some tools; I used a slotted screwdriver some endurance; I relied on my own some time; I didn't have much For the instructions, see the PDF I attached. Print Settings: Printer: Anet A6 Rafts: No Supports: Yes Notes: I used supports with 0mm contact distance (Z-axis)