Anet A6 BLTouch mount - right side - super stiff !

thingiverse

The foundation for this project stems from mwl2's "Anet A6 bltouch mount right side." This particular design stands out as one of the most convenient options available, boasting ease of installation and a non-intrusive layout that does not hinder the extruder assembly's ability to be dismantled when necessary, such as during filament jam removal. However, I encountered an issue with achieving repeatable measurements using the original design. It became apparent that the plate to which the sensor is attached lacks sufficient rigidity. In response, I created a remix of this design, aiming to strike a balance between maintaining its original good design idea and enhancing its structural stiffness to the highest extent possible. Fortunately, these modifications have yielded repeatable measurements and flawless performance. The only drawback of this revised design is that it now requires support during printing.