Anet A6 : Auto Leveling bed AND Cable chain !

pinshape

Hi, This is a major upgrade for the Anet A6 printer: 3D components for holding a promity sensor with a diameter of 18mm (Ref. LJC18A3-H-Z/BX NPN NO, available on eBay) and a cable chain with both ends that fit the printer and sensor holder. You'll also find the "configuration.h" file needed for Skynet Marlin firmware on Anet V1.1 boards. This file contains exact settings for the Anet A6 (Skynet provides one for Anet A8 only at present) and particularly the correct offset dimension "nozzle to sensor" for this specific proximity sensor holder part. To replace the Anet proprietary firmware with Marlin firmware, check out Skynet3d's excellent work here: https://www.facebook.com/skynet3ddevelopment/ Don't forget to replace the "configuration.h" file with this one for A6. Print Settings: Printer: Anet A6 Rafts: No Supports: Yes Resolution: 0.2 Infill: 50% Notes: No problems printing these parts. You'll need approximately 13 pieces of "Cable Chain Left" and 13 pieces of "Cable Chain Right." Alternate them when assembling (refer to pictures). Post-Printing: Sensor Holder... Be cautious with the lower right screw of the nozzle fan: it screws directly into the plastic part without a nut. However, do not tighten it too hard! The upper left screw still requires its nut.