Anet A3 water cooling system parts

thingiverse

LAST UPDATE: 19/04/2019 This is a library of components used to perform a water cooling modification on my Anet A3. It will take some time for me to design, test and build up all the necessary components I need before doing the full installation, so this "project" remains a work in progress until I have everything I need. However, I will only upload a component when it has been fully tested and I am satisfied that it is ready to go. It will get messy giving detailed instructions for each component, so the following applies to all components unless otherwise stated: printed in ABS liquid connectors printed 0.1 - 0.15mm standard parts printed 0.2mm all components have been printed in the orientation provided. With the exception of G1/4 threaded components, anything being fitted into the piping system has been acetone smoothed to ensure a complete seal. All liquid components are pressure tested to guarantee a tight seal. MASTER LIST OF COMPONENTS flow meter stand - 20% infill, no supports, 1%> all axis flow meter paddle - solid, no supports G1/4 to 10mm barb - (requires 13mm I/D x 1.5mm O-ring) - solid, req supports but set X/Y \r\n to keep out of threads! 3%> all axis Pump/resi mount - solid, no supports Radiator mount - 20% infill, supports not "needed" Vertical 90 degree 10mm barb - solid, req supports Horizontal 90 10mm barb - solid, req supports 10mm 90 bulkhead - solid, req supports 10mm to 2 x 5mm manifold (3mm hose will fit) 2 types - solid, req supports single switch housing - 15% infill, req supports (drill or add own cable hole) dual switch housing - 15% infill, req supports digital thermometer housing, 15% infill , req supports