Anet A2 Y-Axis Bed Stabilizer

thingiverse

I loved the original design, but unfortunately, it clashed with the additional components I already had in store. To rectify this issue, I revamped the design to utilize 3M screws paired with a 3M t-slot back. However, my existing bearings proved incompatible with the new setup due to their slightly larger outer diameter compared to those used in the initial design. Consequently, I was forced to make adjustments to accommodate these bearings. Specifically, I reduced the overall height of the design and lengthened the distance between the holes on each leg where the bearing rests. Additionally, I bisected the pin down its centerline to facilitate easier insertion through the pre-drilled holes.