Anet A2/A6 Power Supply Cover

thingiverse

Update 02/02/2019 Added version 03a - 0.3 Fits perfectly, added version 0.3a that can be screwed down and secured firmly, also added two different types of brackets to secure it under a laptop table Update - 19/01/2019 Printed the new version 0.3 and it fits seamlessly. No need to screw into the chassis as both the switch and the actual body fit over the power supply perfectly. Photos will be included. Updated - 18/01/2019 After an 11-hour print I realized the walls are just too thick at 2mm, so reduced them to 1.5mm and added version 0.3 Version 0.3 now accounts for PLA shrinkage. My first print of this was 2mm short on the x-axis. Not sure if it was calibration or the STL so added 3mm to cater for it. ----------------------------------------------------------------------------------------------------------------- All power supply covers for the Anet A2/A6 appeared weak. I designed one to be 2mm thick on each side with reinforced corners. The opening for the non-fused switch is 40mm x 27mm. I cut away at the front and created a 50mm wide hole to allow cables to run from the unit and bend away. Created with Design Spark Mechanical I am still learning, so if you want to remix, files are attached