Amplifier Box

thingiverse

This is an amplifier box/housing for a small class D amplifier module (XH-M543) together with use of a passive tone control board (XH-M802). On the front panel there is a hole to the side of the tone control which is for a push button power switch. On the rear there are 4 holes for RCA chassis mounts and in the middle I used a GX-20 4Pin chassis mount for the power. The parts slide together and are locked down by the lid with 4 screws. No supports required for printing. The amp slides into a slot from the front bottom or rear of the box. it is a tight fit to get into the slot, so jiggling it around may be needed for it to pop into place. Printed using Creality Ender 3 V2