Among Us (magnetic) Hat - Wolf Ears

thingiverse

See the full collection here: https://www.thingiverse.com/ururk/collections/among-us-magnetic-hats Wolf Ears for your crewmate! Includes spot for a 4x1mm magnet. You may wish to use support, but I did not. Initially I was concerned as they make a steep steep angle, but assuming you can print it it makes them kind of fuzzy. If I get complaints, I can spend some time designing a pair that uses a 45 degree angle, but that will either make them shorter or the band deeper. To get it to be two color, I designed an inner ear portion and the headband. You need to print the headband: Hat_Wolf_Ears.stl You need to print one of the following sets of inner ears: Partial pieces - these have a large flat area you can print from (facing up) or facing down: Hat_Wolf_Ears_Inner_Ear_Right_Partial.stl Hat_Wolf_Ears_Inner_Ear_Left_Partial.stl These are identical to the above, but two sides have been shrink by .125. you could alternatively scale it slightly in the X/Y direction if these print too large: Hat_Wolf_Ears_Inner_Ear_Right_partial_shrunk.stl Hat_Wolf_Ears_Inner_Ear_Left_partial_shrunk.stl If you have multi-color capabilities, you may want to use these files instead of the above - it will cause a filament change earlier on: Hat_Wolf_Ears_Inner_Ear_Left.stl Hat_Wolf_Ears_Inner_Ear_Right.stl